DXS/DWS-3200 series CLI Reference Guide
wlan tx-power auto signal-strength
The wlan tx-power auto signal-strength Global Configuration mode command configures the target signal
strength heard at the second-closest AP. To restore defaults, use the no form of this command.
Syntax
wlan tx-power auto signal-strength dbm
no wlan tx-power auto signal-strength
Parameters
•
dbm — Specifies the signal strength, in dBm. (Range: -40 dBm – -80 dBm)
Default Configuration
The default target signal strength is -68 dBm.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the target signal strength heard at the second-closest AP to -50 dBm.
Console (config)# wlan tx-power auto signal-strength -50
Page 559