Table of Contents
Advertisement
set
The set Policy-map Class Configuration mode command sets new values in the IP packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos}
no set
Parameters
•
new-dscp — Specifies a new DSCP value for the classified traffic. (Range: 0-63)
•
queue-id — Specifies an explicit queue ID for setting the egress queue.
•
new-cos — Specifies a new user priority for marking the packet. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
This command is mutually exclusive with the trust Policy-map Class Configuration command within the same
policy map.
Policy maps that contain set or trust Policy-map Class Configuration commands or that have ACL classifications
cannot be attached to an egress interface by using the service-policy (Ethernet, Port-channel) Interface
Configuration mode command.
To return to the Policy-map Configuration mode, use the exit command. To return to the Privileged EXEC mode,
use the end command.
Example
The following example sets the DSCP value in the packet to 56 for classes in policy map called 'policy1'.
Console (config)# policy-map policy1
Console (config-pmap)# set dscp 56
Page 224
QoS Commands
set
Advertisement
Table of Contents
