Radius-Server Timeout - D-Link xStack DWS-3200 Series Cli Manual

RADIUS Commands

radius-server timeout

radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval during which the device waits
for a server host to reply. To restore the default configuration, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
Parameters
•
timeout — Specifies the timeout value in seconds. (Range: 1-30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval on all RADIUS servers to 5 seconds.
Console(config)# radius-server timeout 5
Page 272