Table of Contents
Advertisement
wlan tx-power auto signal-loss
The wlan tx-power auto signal-loss Global Configuration mode command configures the minimum signal loss
difference (transmitted-received) below which two AP radios are considered too close. To restore defaults, use the
no form of this command.
Syntax
wlan tx-power auto signal-loss db
no wlan tx-power auto signal-loss
Parameters
•
db — Specifies the signal loss, in dB. (Range: 20-80 dB)
Default Configuration
The default minimum signal loss difference is 60 dB.
Command Mode
Global Configuration mode
User Guidelines
The Auto Transmit Power algorithm adjusts AP power due to another AP which is very close, because it is
impossible to avoid interference in that case and the APs will have essentially the same coverage zone. The
minimum signal loss is the signal strength difference (transmitted - received) below which two radios are
considered too close.
Example
The following example configures the minimum signal loss difference to 30 dB.
Console (config)# wlan tx-power auto signal-loss 30
Page 560
Wireless WLAN Commands
wlan tx-power auto signal-loss
Advertisement
Table of Contents
