Wlan Rogue-Detect Rogue-Ap - D-Link xStack DWS-3200 Series Cli Manual

DXS/DWS-3200 series CLI Reference Guide

wlan rogue-detect rogue-ap

The wlan rogue-detect rogue-ap Global Configuration mode command sets the status of rouge APs. To restore
defaults, use the no form of this command.
Syntax
wlan rogue-detect rogue-ap mac-address state {known | mitigate}
no wlan rogue-detect rogue-ap mac-address state
Parameters
•
mac-address — The rogue AP MAC address.
•
known — Specify that the rogue AP is known.
•
mitigate — Specify that the rogue AP should be mitigated.
Default Configuration
New.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the status of rogue AP with the MAC address 00-9E-92-4C-73-FCas known.
Console (config-ap)# wlan rogue-detect rogue-ap 00-9E-92-4C-73-FC state known
Page 547