Dot1X Timeout Re-Authperiod - D-Link xStack DWS-3200 Series Cli Manual

DXS/DWS-3200 series CLI Reference Guide

dot1x timeout re-authperiod

The dot1x timeout re-authperiod Interface Configuration mode command sets the number of seconds between
re-authentication attempts. To restore the default configuration, use the no form of this command.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
Parameters
•
seconds — Number of seconds between re-authentication attempts. (Range: 300-4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the number of seconds between re-authentication attempts, to 300.
Console(config)# interface ethernet 1/16
Console(config-if)# dot1x timeout re-authperiod 300
Page 453