Table of Contents
Advertisement
DXS/DWS-3200 series CLI Reference Guide
switchport mode
The switchport mode Interface Configuration mode command configures the VLAN membership mode of a port.
To restore the default configuration, use the no form of this command.
Syntax
switchport mode {access | trunk | general | customer}
no switchport mode
Parameters
•
access — Indicates an untagged layer 2 VLAN port.
•
trunk — Indicates a trunking layer 2 VLAN port.
•
general — Indicates a full 802-1q supported VLAN port.
•
customer — The port is connected to customer equipment. Used when the switch is in a provider network.
Default Configuration
All ports are in access mode, and belong to the default VLAN (whose VID=1).
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines.
Example
The following example configures Ethernet port 1 as an untagged layer 2 VLAN port.
Console(config)# interface ethernet 1
Console(config-if)# switchport mode access
Page 417
Advertisement
Table of Contents
