Extension Output Module - Mitsubishi Electric NZ2GF2B1-16D User Manual

4.3.2

Extension output module

(1) NZ2EX2B1-16T extension transistor output module (screw terminal block, sink
type)
Item
Number of output points
Rated load voltage
Max. load current
Isolation method
Max. inrush current
Leakage current at OFF
Max. voltage drop at ON
OFF  ON
Output response time
ON  OFF
Surge suppressor
Voltage
External power supply
for output part
Current
Output type
Withstand voltage
Insulation resistance
Noise immunity
Protection degree
Wiring method for common
Overload protection
function
Protection function
Overheat protection
function
External interface I/O part
Applicable DIN rail
Applicable wire size For I/O
Applicable solderless Terminal block for
terminal output
RX/RY points
Cyclic transmission
RWr/RWw points
Module power supply Voltage
(supplied from the
Current
main module)
Weight
*1 For how to calculate the current consumption when an extension module is connected, refer to "Calculating Current
Consumption". ( Page 92, Section 4.4)
84
16 points
12/24VDC (ripple rate: 5% or less) (Allowable voltage range: 10.2 to 28.8VDC)
0.5A/point, 4A/common
Photocoupler isolation
Current is limited by the overload protection function.
0.1mA or less
0.3VDC (TYP.) 0.5A, 0.6VDC (MAX.) 0.5A
0.5ms or less
1.5ms or less (resistance load)
Zener diode
12/24VDC (ripple rate: 5% or less) (Allowable voltage range: 10.2 to 28.8VDC)
8mA or less (TYP. 24VDC per common) External load current is not included.
Sink type
500VAC for 1 minute between all DC external terminals and the ground
10M or higher between all DC external terminals and ground (500VDC insulation resistance tester)
Noise voltage 500Vp-p, noise width 1s, noise frequency 25 to 60Hz (DC type noise simulator condition)
IP2X
16 points/common (1-wire, screw terminal block type)
Limited current when overcurrent is detected (overload protection): 1A or more/point
Activated in increments of 1 point.
Activated in increments of 1 point.
18-point two-piece terminal block
Tightening torque range for terminal screw (M3 screw  5.2): 0.43 to 0.57Nm
TH35-7.5Fe, TH35-7.5Al (compliant with IEC 60715)
Core: 0.3 to 2.0 (22 to 14 AWG)
RAV1.25-3 (compliant with JIS C
2805)
V2-MS3
RAP2-3SL
TGV2-3N
16 points
0 points
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
30mA or less (24VDC, all points ON)
0.19kg
NZ2EX2B1-16T
Applicable wire size
0.3 to 1.25
1.25 to 2.0
1.25 to 2.0
1.25 to 2.0
*1
Manufacturer

JST Mfg. Co., Ltd.
Nippon Tanshi Co., Ltd.
NICHIFU Co., ltd.