Appendices; Appendix 1 Details Of Remote I/O Signals; Appendix 1.1 Remote Input Signal; Appendix 1.2 Remote Output Signal - Mitsubishi Electric NZ2GF2B1-16D User Manual

APPENDICES

Appendix 1
The following describes the details of the remote I/O signals assigned to the master/local module.
The assignment of each device number is for the case when the remote I/O signals of the I/O module are assigned as
follows.
Remote input signal
Remote output signal
Appendix 1.1
(1) External input signal X (RX0 to RXF, RX0 to RX1F, RX10 to RX1F, RX20 to
RX2F)
This signal shows the ON/OFF status of External input (X0 to XF, X0 to X1F) of the input module. However, when
the input OFF delay function is enabled, the ON/OFF status of the actual External input (X0 to XF, X0 to X1F) and
that of External input signal X (RX0 to RXF, RX0 to RX1F, RX10 to RX1F, RX20 to RX2F) may not match. For
details on the input OFF delay function, refer to the following.
• Page 181, Section 9.4
Appendix 1.2
(1) External output signal Y (RY0 to RYF, RY0 to RY1F, RY10 to RY1F, RY20 to
RY2F)
Turn on or off External output (Y0 to YF, Y0 to Y1F) of the output module with this signal. However, when the fast
logic function is enabled, the ON/OFF status of External output signal Y (RY0 to RYF, RY0 to RY1F, RY10 to
RY1F, RY20 to RY2F) and that of the actual External output (Y0 to YF, Y0 to Y1F) may not match. For details on
the fast logic function, refer to the following.
• Page 190, Section 9.11
In addition, when the synchronous output timing setting function is enabled, External output signal Y (RY0 to
RYF) becomes disabled. For details on the synchronous output timing setting function, refer to the following.
• Page 206, Section 9.16
256
Details of Remote I/O Signals
Item
16-point module
32-point module
16-point module
32-point module
Remote input signal
Remote output signal
Main module
RX0 to RXF
RX0 to RX1F
RY0 to RYF
RY0 to RY1F
Extension module 1
RX10 to RX1F
RX20 to RX2F
RY10 to RY1F
RY20 to RY2F