CHAPTER 5
This chapter describes the procedures before operation.
Check box
Station number setting
Set the station number for an I/O module.
When using an extension module, connect the extension module to the
main module.
After that, mount the I/O module to a DIN rail.
Connect the I/O module to a power supply, Ethernet cables, and external
devices.
Parameter setting and programming
Set the parameters and create a program.
*1
To replace the module, refer to the point below.
To replace the module, follow the procedure described below:
• Turn off the module power supply and remove the I/O module.
• Prepare a new I/O module and perform the procedure above from "Station number setting" to "Parameter setting
and programming". (The network parameter of the master station does not need to be set again.)
• After checking the operation, restart the control.
PROCEDURES BEFORE OPERATION
Installation
Wiring
CHAPTER 5 PROCEDURES BEFORE OPERATION
Page 138, Section 7.1
Page 139, Section 7.2
Page 141, Section 7.3
Page 146, Section 7.4
Page 153, Section 7.6
Page 156, Section 7.7
Page 160, Section 8.1
Page 168, Section 8.2
Page 233, CHAPTER 11
5
*1
133