Table of Contents
Advertisement
7.6
Wiring of Ethernet Cable
(1) Connecting the Ethernet cable
(a) Connecting
*1
The time taken for the LINK LED to turn on after connection of the cable may vary. The LINK LED normally turns on in a
few second. However, if link-up processing is repeated due to a condition of a device on the line, the longer time may be
required. If the LINK LED does not turn on, refer to the following and take a corrective action.
(Page 245, Section 12.3 (8))
CHAPTER 7 INSTALLATION AND WIRING
1.
Power off the power supplies of the main I/O module
and the external device.
2.
Push the Ethernet cable connector into the main I/O
module until it clicks. Pay attention to the
connector's direction.
3.
Power on the module.
4.
Power on the external device.
5.
Check if the LINK LED on the port into which the
Ethernet cable is connected is on.
7
153
Advertisement
Table of Contents
Troubleshooting
