Program Example For Checking The Fast Logic Enable Or Disable Status - Mitsubishi Electric NZ2GF2B1-16D User Manual

10.5.2
Program example for checking the fast logic enable or disable
status
This section describes the program for reading the fast logic enable status.
When the parameter setting of the fast logic function is completed and Remote READY (RWr0.b11) is on, the fast logic
enable status can be read.
(1) System configuration
(a) Assignment of link devices
The assignment of link devices is the same as that in the following section.
• Assignment of link devices ( Page 215, Section 10.3 (1) (a))
(2) Programming condition
This program reads the enable status of Fast logic setting Y10 to Y17 of the extension output module.
(3) Initial setting description
The initial setting contents are the same as those in the following section.
• Initial setting description ( Page 228, Section 10.5.1 (3))
(4) Devices used by user
Device
X23
D105
M25 to M28
SB47
SW0A0.0
W100.B
(5) Setting procedure
Set the same contents from procedures 1 to 6 in the following section.
• Setting procedure ( Page 217, Section 10.3 (5))
Power supply module
CPU module (Q10UDHCPU)
Master module (QJ71GF11-T2)
Input module (QX10)
Network No.1
X23 Fast logic enable status read switch
Fast logic enable status read switch
Fast logic enable status acquisition
Contact for reading the fast logic enable status
Own station baton pass status (master station)
Baton pass status (station No.1)
Remote READY (RWr0.b11)
CHAPTER 10 PROGRAMMING
Station No.1
Main input module (NZ2GF2B1-16D)
Extension output module (NZ2EX2B1-16T)
Description
QX10 (X20 to X2F)
10
231