Mitsubishi Electric NZ2GF2B1-16D User Manual page 227

(4) Devices used by user
Device
X22
D145
D146
D147
M30 to M41
SB47
SW0A0.0
(5) Setting procedure
Set the same contents from procedures 1 to 6 in the following section.
• Setting procedure ( Page 217, Section 10.3 (5))
(6) Program example
1.
Create the following program with GX Works2.
*1 Setting "1" to the bit corresponding to the clear target device clears the number of ON times of any device. ( Page
283, Appendix 3 (22))
Number of ON times clear switch
Number of ON times clear target device specification
Number of ON times integration value clear completed confirmation
Number of ON times clear target device specification clear
Contact for clearing the number of ON times
Own station baton pass status (master station)
Baton pass status (station No.1)
CHAPTER 10 PROGRAMMING
Description
QX10 (X20 to X2F)
Number of ON times clear command
Number of ON times integration value
clear command Y10 (address:
1200H.b0): Commanded (1)
Clear the number of ON times.
Check Number of ON times integration
value clear completed Y10
(address: 1201H.b0).
If Number of ON times integration
value clear command Y10 (address:
1200H.b0) is set to Not performed (0),
try it again.
If Number of ON times integration
value clear command Y10 (address:
1200H.b0) is set to Completed (1),
perform the clear completion
processing.
Number of ON times integration value
clear command Y10 (address:
1200H.b0): Not commanded (0)
10
*1
225