Festo MSE6-E2M Operating Instruction page 77

Malfunctions
Error Meaning
channel
m = module
number 1
Error number 25, error with the parameterisation of the upper limit value;
Depending on the parameterisation, the module reports the error when monitoring is activated.
Input signals will, however, still be processed. The parameter values entered will be ignored. The
module operates internally with the last valid parameter values.
Em.0 An error has
occurred in the set-
ting of the upper
limit value flow rate
parameter
Em.2 An error has
occurred in the set-
ting of the upper
limit value pressure
parameter
Em.3 An error has
occurred in the set-
ting of the upper
limit value pressure
change parameter
Festo — MSE6-E2M — 2022-08d
Remedy
– Check parameterisation and param-
eterise again with correct parame-
ters è Tab. 53 Upper pressure limit
value module parameter.
Enable parameter
Monitoring: 4828 +
m * 64 + 0, bit
7, monitoring param-
eter error è Tab. 45
Monitor module
parameter .
77