Table of Contents
Advertisement
4
Initial Setup
4.1
Introduction
This section contains information on how to connect the 8743-CL Controller/Driver to
your local line voltage and how to connect the Picomotor to the controller. It also includes
a discussion about the remote interface and the instrument's power-up.
4.2
Grounding
Connect the 8-32 grounding screw to a good earth ground using a dedicated wire of at least
20AWG diameter. See Section 1.4 for advice on making this connection
4.3
Power
Make sure that that power switch is in the off position. Connect the external power supply
to AC and connect the power barrel plug into one of the 8743-CL power inputs. If more
than one unit needs to be connected to the same power supply use the power link cable to
daisy-chain them. Up to 3 units can be powered by one power supply.
4.4
Connecting 8743-CL to a Computer via USB
The 8743-CL Controller/Driver can be connected to a computer with a standard Micro-B
to USB-A cable. If several 8743-CL units have to be connected to the same computer the
user can connect them to a USB hub and then connect the hub to the computer USB input.
Alternatively, the first unit can be connected to the computer with subsequent units daisy-
chained as described in Section 4.7.3 Using RS-485 LAN to Daisy-Chain.
35
Advertisement
Table of Contents
