Newport New Focus Picomotor 8743-CL User Manual page 126

126
NETMASK
Network mask address set.
Description
NETMASK address
Syntax
This command is used to set the controller's network mask address. In order for this setting to
Remarks
take effect, please set the controller to Static IP mode, save this parameter in the controller's
non-volatile memory, and reset the controller.
A netmask is a 32-bit mask used to divide an IP address into subnets and specify the networks
available hosts. In a netmask, two bits are always automatically assigned. For example, in
255.255.225.0, "0" is the assigned network address; and in 255.255.255.255, "255" is the
assigned broadcast address. The 0 and 255 are always assigned and cannot be used.
NOTE: Send this command via USB interface as Ethernet communication may become
Argument
address
IPMODE 0
Example:
GATEWAY
NETMASK 255.255.255.0
IPADDR 192.168.1.101
SM; RS
NETMASK?, IPMODE, IPADDR, SM, RS
See Also
NETMASK?
Network mask address query.
Description
NETMASK?
Syntax
This command is used to query the controller's network mask address.
Remarks
Response
address
NETMASK ?
Example:
255.255.255.0
NETMASK
See Also
unstable during Ethernet settings configuration. While connected via USB, use
the Picomotor application software to send commands (Go to 'Terminal' tab).
Value
nn1.nn2.nn3.nn4
192.168.10.101
Value
nn1.nn2.nn3.nn4
(Get Netmask)
(Returns 255.255.255.0; Netmask)
Description
Network mask address. (Example. 192.168.255.0)
nn1,nn2,nn3,nn4 can be numbers between 0
and 255.
(Set to static IP mode)
(Set gateway address)
(Set Netmask address)
(Set IP address)
(Save and reset system)
Description
Network mask address. (Example. 192.168.255.0)
nn1,nn2,nn3,nn4 can be numbers between 0
and 255.