Usb; Ethernet; 8743-Cl Inputs And Outputs - Newport New Focus Picomotor 8743-CL User Manual

3.6.1

USB

The USB input is a Micro-AB connector. Use a Micro-B to USB-A cable to connect the
8743-CL Controller/Driver to a computer.
3.6.2

Ethernet

The Ethernet input is a standard RJ-45 connector. Use a Cat 5 Ethernet cable to connect
the 8743-CL Controller/Driver to a router, an Ethernet switch, or a computer.
3.6.3 RS-485
There are two RS-485 connectors that accept standard 3.5mm stereo plugs. The two
connectors are connected in parallel inside the Model 8743-CL. (The wiring convention is
TIP = D+, RING = D-, SLEEVE = GND.) These connections are used to simplify the
wiring between an external computer and multiple 8743-CL or 8743-CL Controller/Driver
units.
See Section 4.7.3 Using RS-485 LAN to Daisy-Chain and Section 5.5 RS-485
Communication for more information on setting up these configurations. See the
Accessories Section 2.4 for information on an RS-485 cable that will facilitate normal
multi-unit linking.

8743-CL Inputs and Outputs

33