Newport New Focus Picomotor 8743-CL User Manual page 81

*RCL
Recall command.
Description
*RCL Bin
Syntax
This command restores the controller working parameters from values saved in its non-volatile
Remarks
memory. It is useful when, for example, the user has been exploring and changing parameters
(e.g., velocity) but then chooses to reload from previously stored, qualified settings. Note that
"*RCL 0" command just restores the working parameters to factory default settings. It does not
change the settings saved in EEPROM.
The parameters that can be restored are:
1. Hostname (see HOSTNAME command)
2. IP Mode (see IPMODE command)
3. IP Address (see IPADDRESS command)
4. Subnet mask address (see NETMASK command)
5. Gateway address (see GATEWAY command)
6. Configuration register (see ZZ command)
7. Motor type (see QM command)
8. Desired Velocity (see VA command)
9. Desired Acceleration (see AC command)
10. Units (see SU command)
11. Deadband (see DB command)
12. Following error (see FE command)
13. Closed-loop update interval (see CL command)
14. Hardware configuration register (see ZH command)
15. Quasi-absolute encoder parameters (see AE command)
16. Absolute position search mode (see AD command)
17. Negative software travel limit (see SL command)
18. Positive software travel limit (see SR command)
Argument
Bin
*RCL1
Example
SM, XX
See Also
Value Description
0 Restores factory default settings
1 Restores last saved settings
(Restore from last saved settings)
81