Newport New Focus Picomotor 8743-CL User Manual page 123

IPADDR
IP address set.
Description
IPADDR address
Syntax
This command is used to set the controller's internet protocol (IP) address. An IP address
Remarks
consists of four numbers, each of which contains one to three digits, with a single dot (.)
separating each number or set of digits. Each of the four numbers can range from 0 to 255.
In order for this setting to take effect, please set the controller to Static IP mode, save (SM) this
parameter in the controller's non-volatile memory, and reset (RS) the controller to take affect.
NOTE: Send this command via USB interface as Ethernet communication may become
Argument
address
IPMODE 0
Example:
GATEWAY
NETMASK 255.255.255.0
IPADDR 192.168.1.101
SM; RS
IPMODE, SM, RS
See Also
IPADDR?
IP address query.
Description
IPADDR?
Syntax
This command is used to query the controller's IP address
Remarks
Response
address
IPADDR 192.168.1.101;SM;RS
Example:
IPADDR?
192.168.1.101
IPMODE, IPADDR, SM, RS
See Also
unstable during Ethernet settings configuration. While connected via USB, use
the Picomotor application software to send commands (Go to 'Terminal' tab).
Value
nn1.nn2.nn3.nn4
192.168.10.101
Value
nn1.nn2.nn3.nn4
Description
IP address. (Example. 192.168.1.101)
nn1,nn2,nn3,nn4 can be numbers between 0 and 255.
(Set to static IP mode)
(Set gateway address)
(Set Netmask address)
(Set IP address)
(Save and reset system)
Description
IP address. (Example. 192.168.1.101)
nn1,nn2,nn3,nn4 can be numbers between 0 and 255.
(Set IP address, save, and reset system)
(Get IP address)
(Returns 192.168.1.101; IP address)
123