Connections And Startup; Electrical Connections; Power Connection - Teledyne T750 User Manual

C
2.4.
ONNECTIONS AND
This section presents the electrical (Section 2.4.1) and pneumatic (Section 2.4.2)
connections for setting up and preparing the instrument for initial startup, which is
presented in Section 2.5).
E
LECTRICAL
Note

Power Connection

Adhere to all cautionary messages!
Verify the correct line voltage and frequency configuration on the serial number tag of the
calibrator. Connect the power cord from the calibrator's AC power receptacle to the proper
power source.
24
S
TARTUP
C
ONNECTIONS
To maintain compliance with EMC standards, it is required that
the power cord length be no greater than 3 meters.
WARNING – ELECTRICAL SHOCK HAZARD
High Voltages are present inside the calibrator's case.
•
Power connection must have functioning ground connection.
•
Ensure that the power cord is properly grounded and
•
adequately rated for the power rating of this instrument (see
Specifications table).
Turn off calibrator power before disconnecting or connecting
•
electrical subassemblies.
CAUTION – AVOID PERSONAL INJURY
DO NOT look at the photometer UV lamp; UV light can cause
•
eye damage.
Always wear glasses made from Safety UV filtering glass
•
(plastic glasses are inadequate).
083730750B DCN8606