INFINITY DELTA / KAPPA QUICK REFERENCE GUIDE
Learns the patient's respiration pattern when the Mode selection is
set to Auto
1.
Use Rotary knob to highlight Respirations parameter box, click
2.
Use Rotary knob to highlight Relearn, click
Note: Initiate a relearn if electrodes have been repositioned or if
the patient's breathing pattern changes.
TO TURN ON RESP MARKER
Respiratory markers indicate the time of breath detection. A white
vertical line displays on the Resp waveform where each breath is
detected.
1.
Use Rotary knob to highlight Respirations parameter box, click
2.
Use Rotary knob to highlight Resp. Marker, click
3.
Use Rotary knob to highlight ON, click
4.
A vertical white line is superimposed on the RESP waveform.
NIPB (Non-Invasive Blood Pressure)
TO SET MEASURED INTERVAL CUFF PRESSURES
1.
Use Rotary knob to highlight NBP parameter, click.
2.
Use Rotary knob to highlight Interval Time, click.
3.
Dial to the time interval you want to use, click.
4.
Press NBP Start/Stop fixed key to begin set interval for series
of single NBP measurements
5.
To take the monitor out of interval mode press the NBP
Start/Stop fixed key twice within one second.
6.
A bar appears under the NBP showing the interval time. To
stop a measurement in progress press NBP Start/Stop key.
Temperature Monitoring
1.
Use Rotary knob to highlight TEMP parameter box, click.
2.
Use Rotary knob to make desired changes, click.
SpO
Monitoring
2
THIS GUIDE IS INTENDED FOR REFERENCE ONLY. REFER TO INSTRUCTIONS FOR USE MANUAL.ADDITIONAL INFORMATION
|23
© 2014 Draeger Medical, Inc.