Table of Contents
Advertisement
Placing Originals
>
Detecting the Original Size Automatically
When you select Auto Detect as the paper setting, the following types of paper size are identified automatically.
❏ Placing vertically: A4, B5, A5, 16K
Place the long edge of the original toward the paper feed entrance of the ADF or the left side of the scanner
glass.
❏ Placing horizontally: A3, B4, A4, B5, A5 (scanner glass only), 8K
Place the short edge of the original toward the paper feed entrance of the ADF or the left side of the scanner
glass.
*:The paper is detected when K Size Priority is enabled. However, it may not be detected depending on the
functions you are using. See "Related Information" below for more details.
Note:
The sizes for the following originals may not be detected correctly. If the sizes are not detected, set the size manually on the
control panel.
❏ Originals that are torn, folded, wrinkled, or curled (if the originals are curled, flatten the curl before placing the
originals.)
❏ Originals with a lot of binder holes
❏ OHPs, translucent originals, or glossy originals
Related Information
"Original Size Auto Detection Option:" on page 379
&
Originals that are not Supported by the ADF
Important:
c
Do not feed photographs or valuable original artwork into the ADF. Misfeeding may wrinkle or damage the
original. Scan these documents on the scanner glass instead.
To prevent paper jams, avoid placing the following originals in the ADF. For these types, use the scanner glass.
❏ Originals that are torn, folded, wrinkled, deteriorated, or curled
❏ Originals with binder holes
Originals that are not Supported by the ADF
*
*
*
, 16K
45
Advertisement
Table of Contents
