Epson WorkForce Pro WF-C879RBAM User Manual page 485

Table of Contents

Advertisement

Administrator Information
Related Information
"Setting a Shared Network Folder" on page 456
&
"Configuring a Mail Server" on page 452
&
Using Document Capture Pro Server
By using Document Capture Pro Server, you can manage the sorting method, saving format, and forwarding
destination of a scanning result executed from the printer's control panel. You can call and execute a job previously
registered on the server from the printer's control panel.
Install it on the server computer.
For more information on Document Capture Pro Server, contact your local Epson office.
Setting Server Mode
To use Document Capture Pro Server, set up as follows.
1. Access Web Config and select the Scan/Copy tab > Document Capture Pro.
2. Select Server Mode for Mode.
3. Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4. Click OK.
The network is re-connected, and then the settings are enabled.
Scanning From a Computer
Install the software and check that the network scan service is enabled to scan via a network from the computer.
Software to be installed
❏ Epson Scan 2
This is a scanner driver. If you use the device from a computer, install the driver on each client computer. If
Document Capture Pro/Document Capture is installed, you can perform the operations assigned to the buttons
of the device.
If EpsonNet SetupManager is used, the printer driver is also distributed as a package.
❏ Document Capture Pro (Windows)/Document Capture (Mac OS)
It is installed on the client computer. The jobs registered on a network computer where Document Capture Pro/
Document Capture is installed can be called and run from the device's control panel.
You can scan over the network from a computer. Epson Scan 2 is required to scan.
>
Settings to Use the Printer
485
>
Preparing to Scan

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workforce pro wf-c879r seriesWorkforce pro wf-c879r

Table of Contents