Make Adjustment During Tool Change - Pilz PSENvip RL D P Set Operating Manual

Commissioning
The tools are displayed as follows on the PSENvip display:
Fig.: Tool detection on the PSENvip display
7.3.3

Make adjustment during tool change

To achieve optimum results, the tool should be aligned to an appropriate bending line dur-
ing initial commissioning (see section entitled "Initial commissioning").
There are two ways of starting the function "Adjustment during tool change":
Option 1:
}
Press the <MODE> key.
}
Using the keys
} Press the <ENTER> key to start the Tool Change.
Option 2:
}
Press the
Operating Manual PSENvip RL D P Set
1001641-EN-09
SYSTEM OK OSSD OFF
Tool class 1
TOOL CHANGE
SYSTEM OK OSSD OFF
Tool class 3
TOOL CHANGE
, select the Tool Change option.
( ) key to start the Tool Change.
SYSTEM OK OSSD OFF
Tool class 2
TOOL CHANGE
| 78