Table of Contents
Advertisement
Commissioning
7.2.2
Make adjustment during tool change
The adjustment line is automatically tracked to the tool centre point. The tracking of the ad-
justment line is shown on the web interface.
Prerequisites:
Transmitter and receiver must be exactly aligned to each other and to the centre point of
}
the upper tool, as described under Align transmitter and receiver.
The supply voltage must be present.
}
Operating Manual PSENvip R, PSENvip R LR,PSENvip E
1003449-EN-06
CAUTION!
The manufacturer or operator of the press must use appropriate measures
to ensure safe selection of the "Adjustment during tool change" operating
mode.
CAUTION!
The protective equipment must be tested following a tool change ad-
justment!
Use the standardised test piece to perform a function test, see under Test
the function of the safeguard.
| 92
Advertisement
Table of Contents
