Prepare For Alignment; Adjustment Templates - Pilz PSENvip RL D P Set Operating Manual

Commissioning
7.2.1.1

Prepare for alignment

Please note the following when preparing for alignment:
} Transmitter and receiver must be installed correctly on the press brake (see Chapter 5,
"Installation") and electrically wired (see Chapter 6, "Wiring").
} An upper tool must be fitted to the right and left-hand edge of the press brake.
}
Switch on the supply to the PSENvip.
7.2.1.2

Adjustment templates

Two adjustment templates and the information on the display provide support when aligning
the transmitter and receiver.
Please note the different cut-outs around the cross-hair on the two adjustment templates.
On the left-hand adjustment template in the illustration below, the cross-hair is located
within a square cutout. The different forms make it easier to secure information about the
direction of movement when aligning the transmitter and receiver.
Fig.: Adjustment templates (viewed from the magnet side)
You can select either adjustment template to attach to the transmitter or receiver side.
Operating Manual PSENvip RL D P Set
1001641-EN-09
Magnet
Alignment grid
Magnet
Back gauge with notch
Cross-hair
| 64