Description Of The Units; Overview; Transmitter; Inputs - Pilz PSENvip RL D P Set Operating Manual

Function description
4.4

Description of the units

4.4.1

Overview

The transmitter and receiver form one unit. The receiver contains all the inputs and outputs
required for communication with the CNC controller, programmable safety system, transmit-
ter and press brake. The transmitter merely contains the inputs for controlling the light
source.
Fig.: Transmitter and receiver
}
1: Display
}
2: Receiver
}
3: LED: OSSD status
}

4: Transmitter

4.4.2 Transmitter
The top of the transmitter has a 4-pin M12 connector.
4.4.2.1

Inputs

The receiver uses these standard inputs to control the transmitter's light source. The user
cannot influence these internal signals.
}
TRM_ON
The receiver uses this signal to switch the transmitter's light source on and off.
}
TRM_SYNC
The receiver uses this signal to control the intensity of the transmitter's light source.
Operating Manual PSENvip RL D P Set
1001641-EN-09
1
2
4
3
| 26