Table of Contents
Advertisement
Safety
Example: In unmonitored zones, the use of tools which are not fully detected by the protec-
ted field on the PSENvip (e.g. tools with a radius greater than 25 mm) will lead to the risk of
fingers or hands being crushed or trapped!
Fig.: Crush points when the tool is wider than the protected field
3.2
Standards
To use the PSENvip correctly you will need to have a good knowledge of the relevant
standards and directives. The following gives an overview of the most important standards:
}
EN 61496-1: Safety of machinery - Electrosensitive protective equipment, Part 1
}
CLC/TS 61496-2: Safety of machinery - Electrosensitive protective equipment, Part 2
}
EN 12622: Machine tools - Hydraulic press brakes
}
EN ISO 13849-1: Safety of machinery – Safety-related parts of control systems - Part 1:
General principles for design
}
EN ISO 13849-2: Safety of machinery – Safety-related parts of control systems - Part 2:
Validation
}
EN 61508: Functional safety of safety-related electrical/electronic/programmable elec-
tronic systems
Please note this is not an exhaustive list of safety standards and directives.
3.3
Safety guidelines
Failure to keep to these guidelines will render all warranty and liability claims invalid:
}
All health and safety / accident prevention regulations for the particular area of application
must be observed.
}
Before using the unit it is necessary to perform a safety assessment in accordance with
the Machinery Directive 2006/42/EC.
}
Please note that manufacturers and company operators who use the PSENvip are them-
selves responsible for agreeing the regulations with the relevant authorities and comply-
ing with them.
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 16
Advertisement
Table of Contents
