Enter Overrun - Pilz PSENvip RL D P Set Operating Manual

Commissioning
7.4

Enter overrun

The max. overrun is a press brake variable that will depend on the machine type. Once the
closing movement has stopped, the max. overrun must not be exceeded.
The overrun is entered during configuration via the keypad on the PSENvip receiver.
Normally, the factory-assigned overrun is sufficient and does not have to be configured.
To enter the overrun, follow the instructions below:
}
Switch off the voltage to the PSENvip.
}
Press the <ESC> + <ENTER> keys and keep them held down.
}
Switch the supply voltage back on.
} Release the <ESC> + <ENTER> keys when Password? appears on the display.
}
Enter the password within 10 s.
To do this, press the following keys in the specified sequence: 1.
The menu for entering the overrun will appear.
Operating Manual PSENvip RL D P Set
1001641-EN-09
NOTICE
The overrun may only be entered by the press brake manufacturer or suit-
ably authorised persons.
WARNING!
The protected field is reduced when the overrun is too low
A reduced protected field may lead to serious injury and death.
If you require a different overrun path than the factory-set path, then use the
value indicated by the manufacturer on the nameplate of the press brake, or
a higher value. If you enter a lower value for the overrun, the protected field
will also be reduced to an unpermitted level.
INFORMATION
The PSENvip will need to be restarted if the entry
- Was invalid
- Took longer than 10 s.
, 2. , 3. , 4. .
| 80