Box Bending Protected Field Mode - Pilz PSENvip RL D P Set Operating Manual

Function description
4.5.2

Box bending protected field mode

With box bending protected field mode, the front segments of the protected field are
blanked. This protected field mode is used for workpieces that need to be bent several
times, e.g. a box. Interruption of the front segments is to be expected and does not cause
the press stroke to stop.
The central segments of the protected field are behind the bending line. The box's side
panels must not encroach into the central segments.
If the central or rear segments of the protected field are interrupted, the OSSDs switch to
the OFF state.
Fig.: Box bending protected field mode
Legend:
}
1: Front segments of protected field are blanked
The box bending protected field mode is only active for one press stroke and must be ac-
knowledged by the operator before it is initiated.
Operating Manual PSENvip RL D P Set
1001641-EN-09
WARNING!
Risk of injury due to reduced protected field!
Around the bending line there is an increased risk of crushing and trapping
of fingers or hands because the front segments of the protected field are
blanked.
Make sure that the workpiece is handled correctly (see Chapter "Safety").
1
| 38