Remote Register; Drive Remote Register - YASKAWA CC-Link SI-C3 Installation Manual

Signal Name
Remote Station
RX1B
Ready
RX1C -
Reserved
1F
*1 Terminals are different for different drive models. Refer to
of the Drive on page 53
◆

Remote Register

Note:
Remote register data varies between drives and D1000 that support this option.
■

Drive Remote Register

PLC → Drive
Remote
Regis Name
ter
• Sets the code number of the items to be displayed by
• The monitor value is stored in register RW
Monitor
RW
W0
Code
• While RW
• Specifies the source of the frequency reference. The
• When RYE (frequency setting reference 2 flag) is
Fre
RW quency
W1
Setting
YASKAWA TOEP C730600 83A CC-Link Installation Manual
ON: D1000 is ready to operate.
for more information.
Table 8.5 Remote Register (PLC → Drive)
Description
the monitor.
enabling RYC (the monitor execution request flag)
after the monitor code has been set.
is updated, RXC (during monitor flag)
R0
remains ON.
value set to this register becomes the main frequency
reference when RYD (frequency setting reference 1)
is enabled.
enabled, then the value for frequency reference 1 is
written and saved to EEPROM
Note:
Parameter o1-03 [Frequency Display Unit
Selection] determines the setting drives for the
frequency reference.
Description
-
Terminals that Change depending on the Model
by
R0
RYC (Monitor Execute Request)
• RYD (Frequency Reference
*1 • RYE (Frequency Reference
.
8 CC-Link Data List
Comments
(Default)
-
-
Request Flag
1)
2)
49