YASKAWA CC-Link SI-C3 Installation Manual page 43

Signal Name
Motor Revolutions /
RYB Output Frequency
Switch
RYC Monitor Reference
Frequency Reference
RYD
1
Frequency Reference
RYE
2
Command Code
RYF
Execute Request
RY10 -
Reserved
13
Terminal S1
RY14
Function
Terminal S2
RY15
Function
RY16 -
Reserved
19
YASKAWA TOEP C730600 83A CC-Link Installation Manual
Description
Sets data contents for the remote register RW
ON: Output Frequency
OFF: Motor revolutions
ON: Monitor data specified in the monitor code is set to
remote register RW .
R0
Frequency set to remote register RW
operating frequency for the drive.
Sets the frequency in the remote register RW
parameter d1-01 [Frequency Reference 1] and as the
drive's main frequency reference at the same time.
Note:
If the frequency reference is set to be provided by
the keypad (i.e. b1-01 = 0 [Frequency Reference
Selection 1 = Keypad]), then switching ON RYE
changes the frequency reference.
Request to execute the command code.
Multi-Function Input: H1-01 [Terminal S1 Function
Selection]
Multi-Function Input: H1-02 [Terminal S2 Function
Selection]
.
R1
becomes the
W1
to
W1
-
-
8 CC-Link Data List
Comments
(Default)
Disabled in V/f
Control or PM Open
Loop Vector mode.
RW is the output
R1
frequency.
When switching
between monitors
using RYC (Monitor
Reference), RYC
needs to be turned
OFF and then back
ON again after the
monitor code has
been changed.
When switching ON
RYD, the frequency
in the remote register
RW will always
W1
reflect the operating
frequency for the
drive.
All parameter
settings are saved
when this flag is
switched ON.
Triggered by the
rising edge of the
signal.
Triggered by the
rising edge of the
signal.
-
Function is disabled
when for H1-01 = 40
[Forward Run
Command =
Forward RUN (2-
Wire)].
Function is disabled
when for H1-01 = 41
[Forward Run
Command = Reverse
RUN (2-Wire)].
-
43