YASKAWA CC-Link SI-C3 Installation Manual page 20

5 Installation Procedure
3.
Install the option (A) into the CN5-A connector (C) on the drive and use the
included screws (B) to put it in place.
A - Option
B - Included screw
4.
Use one of the remaining included screws (B) to connect one end of the ground
wire (C) to the ground terminal (D). Use the last remaining included screw (B) to
connect the other end of the ground wire (C) to the remaining ground terminal and
installation hole on the option (A).
Tighten the screws to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
20
C - Connector CN5-A
Figure 5.4 Install the Option
YASKAWA TOEP C730600 83A CC-Link Installation Manual