YASKAWA CC-Link SI-C3 Installation Manual page 22

5 Installation Procedure
A - Route wires through the openings
provided on the left side of the
front cover.
*1 If there is wiring outside the enclosure, the drive will not meet Enclosed wall-mounted
type (IP20/UL Type 1) requirements.
6.
Firmly connect the CC-Link communication cable to the option modular connector
(CN1).
Isolate communication cables from main circuit wiring and other electrical and
power lines. Make sure that you firmly connect the cable end. (Refer to
Connection Diagram on page
on page 31
Note:
Do not connect or disconnect the communication cable while the drive is powered up or while the drive
is in operation. Failure to obey can cause a static discharge, which will cause the option to stop
working correctly. Cycle power on the drive and option to start using the option again.
7.
Reattach the front cover (A), terminal cover (C), and keypad (B).
Refer to the drive manuals for more information.
NOTICE
comply could cause erroneous operation.
22
*1
Figure 5.6 Wire Routing Examples
30). Refer to
for more information.
Do not pinch cables between the front covers and the drive. Failure to
B - Use the open space provided
inside the drive to route option
wiring.
Communication Cable Specifications
YASKAWA TOEP C730600 83A CC-Link Installation Manual
Option