Install The Keypad In A Control Panel Or Another Device; Operate The Keypad From A Remote Location; Connect The Keypad From A Remote Location - YASKAWA CR700 Technical Manual

2.7

Install the Keypad in a Control Panel or Another Device

Operate the Keypad from a Remote Location

◆
You can remove the keypad from the drive and connect it to a remote control extension cable 3 m (9.8 ft) long to
make operation easier when you cannot access the drive. It is not necessary to open or close the panel door to
operate a drive that is in a control panel. To order optional accessories, contact Yaskawa or your nearest sales
representative.
Name
WV001: 1 m (3.3 ft)
Keypad Remote Cable
WV003: 3 m (9.8 ft)
Installation Support Set A 900-192-933-001
Installation Support Set B 900-192-933-002

Connect the Keypad from a Remote Location

◆
Use the information in Table 2.3
Installation Method
Outside of the control panel
Inside of the control panel
Note:
Installation support sets are sold separately. If there are weld studs inside the control panel, use installation support set B. Contact
Yaskawa or your nearest sales representative to make an order.
NOTICE: Do not let unwanted objects, for example metal shavings or wire clippings, fall into the drive during drive installation.
Put a temporary cover over the drive during installation. Remove the temporary cover before start-up. Unwanted objects inside
of the drive can cause damage to the drive.
External Dimensions of Keypad
■
W H
65 106
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual

2.7 Install the Keypad in a Control Panel or Another Device

Option Model
To connect the keypad and drive.
This option is an RJ-45, 8-pin straight-through UTP CAT5e cable.
To attach the keypad to the control panel. This option uses screws.
To attach the keypad to the control panel. This option uses nut clamps.
Use this option when weld studs are located in the control panel.
to install the keypad in the best location for your application.
Table 2.3 Keypad Installation Method
Simplified installation is possible. Separate installation
support sets are not necessary.
Keypad does not extend farther than the front of the
control panel.
Figure 2.10 Exterior and Mounting Dimensions
Table 2.4 Exterior Dimensions (mm)
D D1 D2
16 8.2 1.6
Intended Use
Features Necessary Tools and Installation Support Sets
Phillips screwdriver #2 (M3)
• Phillips screwdriver #2 (M3, M4)
• Installation support set A (for mounting with screws,
model: 900-192-933-001)
• Phillips screwdriver #2 (M3)
• Wrench (M4)
• Installation support set B (for mounting with nut
clamp, model: 900-192-933-002)
*1
R W1
53.8 44
W2 H1 d
15 78 M3
2
41