Communication Cable Specifications - YASKAWA CC-Link SI-C3 Installation Manual

5 Installation Procedure
NOTICE
board and the drive. Failure to comply could cause erroneous operation.
Note:
• Replace the keypad connector then install the keypad.
• Put the keypad connector tab into the holder when you install the keypad connector to the holder.
A - Keypad connector tab
B - Keypad connector
C - Drive front cover
Figure 5.13 Install the LED Status Ring board, Front Cover, and Keypad
7.
Set drive parameters in
performance.
◆

Communication Cable Specifications

Use only CC-Link dedicated communication cable. The Yaskawa warranty does not cover
other cable types. For more information on cables, refer to the CC-Link website at http://
www.cc-link.org/.
Yaskawa recommends using CC-Link cables suitable for the conditions listed in the
following table.
Item
Cable Type
External Diameter
28
Do not pinch cables between the front cover or the LED Status Ring
Related Drive Parameters on page 34
Table 5.2 Communication Cable Requirements
D - Keypad
E - LED Status Ring board
Specifications
triple-core shielded twisted-pair cable
8.0 mm maximum
YASKAWA TOEP C730600 83A CC-Link Installation Manual
for correct option