D1000 Remote Register - YASKAWA CC-Link SI-C3 Installation Manual

8 CC-Link Data List
o1-03 [Frequency Display Unit Selection]
Note:
Refer to the instruction manual for the drive the CC-Link Option is connected to for more details on parameter
settings.
■

D1000 Remote Register

PLC → D1000
Remote
Regis Name
ter
• Sets the code number of the items to be displayed by
• The monitor value is stored in register RW
Monitor
RW
W0
Code
• While RW
RW Reserved
W1
• Sets the command code to execute functions, for
Com
RW mand
W2
• When RYF (command code execution request flag)
Code
52
Table 8.8 RW (Output Frequency) Units List
R1
0
1
2
3
Table 8.9 Remote Register (PLC → D1000)
Description
the monitor.
enabling RYC (the monitor execution request flag)
after the monitor code has been set.
is updated, RXC (during monitor flag)
R0
remains ON.
-
example the fault reset, fault history, and parameter
read.
Note:
Refer to the MEMOBUS/Modbus Data Table in
Appendix C of the instruction manual for D1000 the
CC-Link option is connected to for a list of monitor
data using the MEMOBUS/Modbus message area.
is enabled, the drive executes the specified
command. When the command is carried out, RXF
switches ON.
Note:
The value set to RW (write data) should be
W3
adjusted accordingly to match changes to any
parameter settings.
Frequency Reference Units (RW
0.01 Hz units (output frequency)
0.01% units (percent of maximum output frequency)
min -1 units (calculated from the maximum output
frequency and the number of motor poles)
User-set (according to parameter o1-10 [User Units
Maximum Value], and o1-11 [User Units Decimal
Position])
by
R0
RYC (Monitor Execute Request)
RYF (Command Code Execute
Request)
YASKAWA TOEP C730600 83A CC-Link Installation Manual
)
R1
Request Flag
-