YASKAWA CC-Link SI-C3 Installation Manual page 51

Remote
Regis Name
ter
• When RYB is enabled, the motor revolutions are
• The output frequency are stored in V/f Control or
• Sets 00 (Hex.) when there are no problems with
• Sets 01 (Hex.) through 03 (Hex.) if an error occurs.
• Response Code:
Response
RW
R2
Code:
Read
RW Data is set according to the command code.
R3
Data
Data in RW (Output Frequency) and Units
R1
Table 8.7 Drive RW
Conditions
A1-02
[Control Method
Selection] Output Frequency
*1
0, 5
1, 2, 3, 4, 6, 7, 8
*1 Controls in the same way as A1-02 = 1 [Control Method Selection = V/f Control with Encoder] in A1-02 =
0 [V/f Control] and H6-01 = 3 [Terminal RP Pulse Train Function = Speed Feedback (V/F Control)].
YASKAWA TOEP C730600 83A CC-Link Installation Manual
Description
-1
stored as min . Here, RXB (actual motor rotations)
is enabled.
PM Open Loop Vector mode.
RYB setting is disabled.
RW (Command Code) and RW
W2
00 (Hex.): Normal
01 (Hex.): Write-mode error (attempted to write
during run, etc.)
02 (Hex.): Command code error
03 (Hex.): Data setting range error
R1
RYB
(Motor
Revolutions/ (Actual Motor
Rotations)
Switch)
OFF (output
-
OFF (motor
revolutions) revolutions)
ON (output OFF (output
frequency)
(Write Data).
W3
(Output Frequency) Data List
Drive → PLC
RXB
RW
Output Frequency
frequency)
ON (motor
Motor revolutions
Output Frequency
frequency)
8 CC-Link Data List
Check Flag
RXF (Command Code Execute
Complete)
Data RW
R1 R1
Set in the drives
specified by o1-03
[Frequency Display
Unit Selection] in
output frequency.
min
Set in the drives
specified by o1-03
[Frequency Display
Unit Selection] in
output frequency.
Units
-1
51