Receiver And File Maintenance; Downloading Files To A Computer - Javad TRIUMPH-1 Operator's Manual

• Standalone – where the receiver computes 3D coordinates in autonomous mode without using
differential corrections.
• Code differential – where the Rover receiver computes the current relative coordinate in
differential mode using only pseudo ranges.
• RTK float – where the Rover receiver computes the current relative coordinates in differential
mode using both pseudo ranges and phases; however, with a float solution, the phase ambiguity is
not a fixed integer number and the "float" estimate is used instead.
• RTK fixed – where the Rover receiver computes current relative coordinates, with ambiguity
fixing, in differential mode. The LQ field reflects the status of the received differential messages
and contains the following information:
• Data link quality in percentage
• Time (in seconds) elapsed since the last received message
• Total number of received correct messages (dependent on the message type received)
• Total number of received corrupt messages (dependent on the message type received)
If the receiver is not (for some reason) receiving differential corrections, or if none of the ports has been
configured to receive differential corrections, the LQ field will either be empty or it will look like this:
100%(999,0000,0000).

9. Receiver and File Maintenance

If post-processing the data after completing a measuring, the data in the receiver's memory will need to
be downloaded to a computer. Downloading and deleting files will also prepare the receiver's memory for
the next measuring. Occasionally, the receiver's NVRAM may need to be cleared to eliminate
communication or tracking problems. As project expectations expand, the receiver's OAF may need to be
updated to provide expanded operation and functionality. The receiver requires firmware to properly
operate and provide appropriate functionality. As JAVAD GNSS releases firmware updates, loading these
updates into the receiver will ensure that the receiver operates at its full potential.

9.1. Downloading Files to a Computer

When your measuring finishes, you can download your measuring files to a computer for storage, post-
processing, or backup. Also, the DELTA memory holds a finite amount of files and information, so
downloading the files to a computer ensures that no files are lost. You should download files as soon as
possible after collecting data at the jobsite. NetView provides a File Manager to download files to your
computer and delete files from the receiver DELTA.
1. Connect your receiver and computer. See "Connecting the Receiver and a Computer" on page 28
for this procedure. Start NetView. Establish connection between NetView and receiver.
www.javad.com
Description and Operation
Receiver and File Maintenance
Downloading Files to a Computer
55