Page 1
Version 1.2 Last Revised November 12, 2019 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved. The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
JAVAD GNSS products. It is designed to ARE NO OTHER WARRANTIES. JAVAD GNSS DISCLAIMS assist owners with the use of TRIUMPH-3 and its use ANY IMPLIED WARRANTY OF MERCHANTABILITY OR is subject to these terms and conditions (the “Terms FITNESS FOR ANY PARTICULAR USE OR PURPOSE.
You agree to destroy the Software and man- not be treated as household waste. By ensuring this ual upon termination of your use of TRIUMPH-3. All product is disposed of correctly, you will help prevent ownership, copyright and other intellectual property potential negative consequences for the environment rights in and to the Software belong to JAVAD GNSS.
This Class А digital apparatus meets all requirements your local dealer. Alternatively, request technical sup- of the Canadian Interference-Causing Equipment port using the JAVAD GNSS World Wide Web site at: Regulations. www.javad.com Cet appareil numérique de la classe А respecte toutes To contact JAVAD GNSS Customer Support use the les exigences du Réglement sur le matériel brouilleur...
GNSS signals. Additionally ability, and integrity needed for fast and easy data TRIUMPH-3 is equipped with the Wi-Fi and Bluetooth collection . modules, the internal 4G/LTE/3G card (optional), UHF When calculating an absolute position, a stationary...
• < 0.25 m (post-processing) • Real-time Data Input/Output JPS, RTCM SC104 * For the full list of standard and optional features see www.javad.com ** For good observation conditions and proper length of observation session ***Li-Ion batteries are the temperature limiting factor...
Fahrenheit (100 degrees Celsius). Excessive heat can cause serious damage and possible explosion. • Inclinometers and compass integrated Warning: The batteries (or batteries installed) shall not be User Interface exposed to excessive heat such as sunshine, fire or the like. www.javad.com...
Receiver-to-SAE power cable shall be To check the status of the internal batteries, view the BAT LED or check the status using JAVAD GNSS used. The external power supply needs to be Listed for US and Certified for EU countries, it needs also to software.
Class 10 or better. Depending upon which options you chose when MicroSIM you purchased your TRIUMPH-3, the type of exter- If you work in areas with good cell coverage that nal UHF antenna shown in this discussion may differ...
Managing and Operating Receiver using NetView This software is available on the JAVAD GNSS web- site. If downloading the program(s) from the website, extract the program’s files into a folder on your hard drive. The following sections describe installing this software, and other sections throughout the manual describe using this software with the receiver.
• Configure one receiver as a Base station and the other receiver as a Rover. • Set up the Base receiver over a known point to begin collecting static observation data. Set up the Rover receiver to begin collecting static or kine- matic observation data. www.javad.com...
Page 15
5. Open Positioning tab and set the Elevation mask to 15 degrees . Base tab Figure 7. 7. To set up the rover, open Positioning tab and set the Position Computation Mode - this drop-down list box allows selecting the mode of position computa- www.javad.com...
Page 16
Figure 9. Parameter Base Rover Input The same correction type as Base has Output Select correction type. Period (sec) period correction output Baud rate Baud rate for the corresponding receiver port RTS/CTS Enable 10. Open Advanced tab, and then Multipath www.javad.com...
Receiver setup for either post-process or RTK sur- To start survey TRIUMPH-3 should be set up on a veys is the same. tripod or in a pole. TRIUMPH-3 has 5/8” mount to con- nect to monopod, to tripod or to surveying pole. Measure Antenna Height...
• To begin collecting data, press and hold the Re- cessed using post-processing software (for example, cord button (for more than one second and less JAVAD GNSS Justin). than five seconds). • Release the Record button when the REC (record- Kinematic (Stop &...
Usually, the receiver will start to output the coor- receiver requires firmware to properly operate and dinates of the antenna’s phase center along with the provide appropriate functionality. As JAVAD GNSS re- solution type within 10–30 seconds. However, UHF ra- leases firmware updates, loading these updates into...
Loading OAFs seconds. Release the power button while continuing to hold the FN button. JAVAD GNSS dealers provide customers with OAF files. For any OAF related questions, E-mail at sup- Wait until the four LEDs blink yellow. port@javad.com. Please have your receiver ID num- Release the FN button.
Use the latest firmware ver- free port and start NetView. sion, available for download from the JAVAD GNSS • Change the Input for the port used for connec- website, to ensure your receiver has the most recent tion to “Command”.
This First!” for some solutions that may fix the issue. • Conduct your measuring when PDOP values are To contact JAVAD GNSS Customer Support use the low. QUESTIONS button available on the www.javad.com. • The elevation mask is above 15 degrees.
Need help?
Do you have a question about the TRIUMPH-3 and is the answer not in the manual?
Questions and answers