Javad TRIUMPH-1 Operator's Manual page 17

The BT (Bluetooth) LED indicates the level of activity at the Bluetooth® wireless technology
communication link:
• Green – the Bluetooth® module is on and a connection has been established.
• Yellow – the Bluetooth® module is on and a connection is establishing.
• Red – connection is not established.
• No light – the Bluetooth® module is not active.
The MOD (modem) LED displays the status of the modem.
• Green – the UHF modem/GSM module is on and a connection has been established.
• Yellow – marginal connectivity.
• Red – connection is not established.
• No light – the UHF modem/ GSM module is not active.
The SAT (satellites) LED displays the number of tracked satellites.
• Green – eight and more satellites.
• Yellow – five to seven satellites.
• Red – less than five satellites.
• No light – no satellites.
Effective number of satellites are total number of satellites tracked minus the number of non-GPS
systems tracked. E.g. if 8 GPS and 5 GLONASS are tracked the effective number of satellites is 12.
The POS (position) LED indicates position solution for current surveying mode:
• Green – Fixed/Diff position solution is obtained.
• Yellow – Float/No-Diff position solution is obtained.
• Red – No position.
• No light - no satellites.
The REC (record) LED displays the data recording status and blinks on each recording.
• Green – recording data.
• Yellow – less than 10 min memory left.
• Red – memory is full.
• No light - not active.
The On/Off (power) button turns the receiver on and off.
The FN (function) button switches the receiver between post-processing modes, starts/stops data
recording, and changes the baud rate of the serial port to 9600. Holding FN down while pushing ON/OFF
button between 4 to 8 seconds (during this period four LEDs blink yellow) will clear the NVRAM.
Holding FN down while pushing ON/OFF button for more than 30 seconds resets the receiver.
www.javad.com
Description and Operation
Getting Acquainted
MinPad
17