Table of Contents
Advertisement
Quick Links
TriPad
User Manual
Version 1.1
Last Revised November 14, 2012
All contents in this manual are copyrighted by JAVAD GNSS.
All rights reserved.The information contained herein may not be used, accessed, copied,
stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express written
consent from JAVAD GNSS
Advertisement
Table of Contents
Related Manuals for Javad TriPad
Summary of Contents for Javad TriPad
- Page 1 Version 1.1 Last Revised November 14, 2012 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved.The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express written...
- Page 2 © JAVAD GNSS Inc., 2012 www.javad.com...
-
Page 3: Table Of Contents
4. NVRAM clearing with TriPad ........ - Page 4 www.javad.com...
-
Page 5: Chapter 1. Introduction
Chapter 1 NTRODUCTION TriPad (Figure 1) is a simple user interface that consists of keys and LEDs, which can control and display the operation of the receiver. ON/OFF FN button button REC LED STAT LED Figure 1. TriPad TriPad brings a new level of automation to the GNSS field operation. Its function is similar to what is... - Page 6 TriPad as usually has the following keys: • an ON/OFF key (PWR) • Function/recording key (FN). In addition, TriPad has protection against stuck keys (e.g. when a key is held down unintentionally for a long time by other objects in a backpack). www.javad.com...
-
Page 7: Chapter 2. Keys And Leds
Chapter 2 EYS AND This chapter provides an overview of the TriPad’s keys and LEDs. This information is split into the following sections: 1. PWR Key To turn on the receiver, push the PWR key and release it. To turn it off, press the PWR key for more than 1 and less then 4 seconds, during this period the STAT LED remains off to assist you. - Page 8 If FN key mode is «Occupation mode switch» Green Release to start recording (Kinematic or Static post-processing occupation mode). Pressed for 5–8 seconds Release to turn serial port A baud rate to 9600 bps. Pressed for > 8 seconds No light No function. www.javad.com...
-
Page 9: Nvram Clearing With Tripad
No light No function (data recording still on). 4. NVRAM clearing with TriPad It is possible to clear NVRAM using only TriPad. To do that: • Turn the receiver OFF. • Press and hold FN button. • Press and release PWR button to turn the receiver ON. - Page 10 900 Rock Avenue, San Jose, CA 95131 USA Phone: +1(408)770-1770 Fax: +1(408)770-1799 www.javad.com Copyright © JAVAD GNSS, Inc., 2012 All rights reserved. No unauthorized duplication.
Need help?
Do you have a question about the TriPad and is the answer not in the manual?
Questions and answers