Real-Time Kinematic Measuring; Advanced->Loop Management - Javad Prego Operator's Manual

S E T U P A N D M E A S U R I N G
3
Measuring with the Prego

Real-time Kinematic Measuring

Real-time kinematic (RTK) is a differential GPS process where information,
such as differential corrections, is transmitted in real-time from a Base
station to one or more Prego Rover stations.
3-12 Prego Operator's Manual
• Static mode – disable
Figure 3-7. Advanced->Loop Management
4.Set up the Rover at a start point with unknown coordinates and press
the power key. Pause for several minutes while the receiver compiles
an almanac.
5.Check the STAT light for satellites tracked. Record the antenna height
and a start point or trajectory name in the field notes.
6.Press the FN key for one to five seconds to begin logging data in
kinematic mode (the antenna status is kinematic).
7.Move the Rover receiver along the selected trajectory.
8.Once the Rover receiver reaches the end point of the trajectory, pause
for several minutes.
9.When finished, press the FN key to stop logging data and turn off the
Rover.
10.Stop data logging and turn off the Base station receiver.
www.javad.com