Javad Prego Operator's Manual page 65

Scenario
1
Receiver
data logged
to file
specified.
2
Receiver
data logged
to default
file.
3
Receiver
data logging
not started
and file
specified.
4
Receiver
data logging
is off and no
file
specified.
• After pressing the MinPad power key.
• After resetting the receiver (with PCView or the Reset key).
• After taking the receiver out of sleep mode.
www.javad.com
Table 2-1 on page 2-29 gives the different scenarios available and the results
after power is restored to the receiver. "Specified file" refers to the file name
entered in the Always append to file parameter.
Table 2-1. Data Recording Parameter Behavior
Before
Power
Off
Failure
Data logging will
not resume when
power is restored.
Data logging will
not resume when
power is restored.
No file will open
with this name.
Data logging will
not start when
power is restored.
Data logging will
not start when
power is restored.
Also, if Always is enabled, your receiver will automatically start logging
data (to a newly created or an existing file) in the following three cases:
Enabled Radio Button Results
On
Receiver will
resume data
logging to the
same file when
power is restored.
A new log file
will open when
power is restored
and data will log
to this file.
No file will open
with this name.
Data logging will
not start when
power is restored.
Data logging will
not start when
power is restored.
C O N F I G U R A T I O N
MinPad Configuration
Always
Receiver will
resume data
logging to the
same file when
power is restored.
A new log file
will open when
power is restored
and data will log
to this file.
A log file with
this name will
open and data
logging will start
after power is
restored.
A log file with a
default name will
open and data
logging will start
after power is
restored.
Prego Operator's Manual 2-29