Kinematic Measuring; Advanced->Loop Management - Javad Prego Operator's Manual

S E T U P A N D M E A S U R I N G
3
Measuring with the Prego
4. Click the Loop Management tab and set the following parameters,
5. Set up the receiver, or an external antenna and receiver, as described in

Kinematic Measuring

You can use the kinematic measuring method in two ways:
3-8 Prego Operator's Manual
• Carrier Multipath Reduction – enable
Figure 3-4. Advanced->Multipath
then click Apply (Figure 3-5):
• Enable Common tracking – enable
• Static mode – enablel
Figure 3-5. Advanced->Loop Management
"Prego Setup" on page 3-1.
• Stop and Go measuring
• Kinematic continuous measuring
www.javad.com