Javad TRIUMPH-LS Update To User Manual

Update to user manual for TRIUMPH-LS
J-Field version of 3.0.5.280 or higher.
Introduction
Let's set the record straight: J-Mate is not a total-station. J-Mate and TRIUMPH-LS together make the "Total
Solution" which is a combination of GNSS, RTK, camera, angle encoders and laser range measurements
that together do, conveniently and cost-effectively, a lot more than a total station. For long distances, you use
GNSS and for short distances (maximum of 300 feet in Direct mode and 100 feet in Remote/Robotic mode),
you use the J-Mate along with the TRIUMPH-LS. Together they provide RTK level accuracy (few centimeters)
in ranges from zero to infinity.
J-Mate is a bridge between
RTK and areas that GNSS
signal is not available.
As with the TRIUMPH-LS, with the
J-Mate we also provide software im-
provement updates regularly and free
of charge. Download the J-Mate up-
date in your TRIUMPH-LS and then
inject it to the J-Mate.
Figure 1
Connecting the TRIUMPH-LS to the J-Mate
TRIUMPH-LS communicates with the J-Mate through Wi-Fi. Turn on both the TRIUMPH-LS and the J-Mate.
Click the Setup icon on the TRIUMPH-LS Home screen (Figure 1) and click "J-Mate" to connect to J-Mate.
(Figure 2) The J-Mate SSID will be in JMatexxxxx format, where xxxxx is your J-Mate's serial number. After
Wi-Fi connection is established, click the "Collect" or "Stake" icons according to your job.
Prepare for Collect
rows), 2) execute it (by GNSS, J-Mate Direct, or J-Mate Remote), and 3) "Review" it.
Figure 3
: Click "Collect" in Figure 1 to get to Figure 3 to a) prepare for your job (the first three
Figure 2
RTK
status
Figure 4
Com
status
Level