Prego Setup; Setup Antenna - Javad Prego Operator's Manual

S
This chapter describes:

• Prego setup

• Static measuring with the Prego
• Kinematic measuring with the Prego
• RTK Base station setup
• RTK Rover setup
Prego Setup
To set up the Prego for measuring you need to:
1. Set up the antenna and measure its height. See "Setup Antenna" on page 3-1
1.
2.

Setup Antenna

www.javad.com
ETUP AND
and "Measure the Antenna Height" on page 3-2.
Set up the Base and Rover receivers. See "Setup Receiver" on page 3-5.
Begin collecting data. See "Collect Data" on page 3-5.
This section assumes you have already configured your receiver using
PCView.
1. Center the antenna over the point at which data will be collected. For
most applications, this should be at a location with a clear view of the
sky.
M
EASURING
3
Prego Operator's Manual 3-1