Javad Prego Operator's Manual page 80

S E T U P A N D M E A S U R I N G
3
Measuring with the Prego
Notice: Remember, both receivers must collect data from the same satellites at
the same data recording rate and with the identical elevation mask
angles.
Notice: Remember, if the REC LED blinks green, the current
mode is dynamic, if it blinks orange, the current mode is
static.
3-10 Prego Operator's Manual
Figure 3-6. Rover MinPad Configuration
3.Set up the Rover at an unknown point and press power.
4.Press the FN key for one to five seconds. Allow the Rover to collect
data during the time you specified. The REC LED will be orange.
5.Check the STAT light for satellites tracked.
6.When finished, quickly press and release the FN key to assign the
Rover to kinematic.
7.Move the Rover to the next location (measuring point), and press the
FN key for less than a second to collect the data in static mode for 2 to
10 minutes.
8.Repeat steps five and six until all the points have been surveyed. The
occupation time for the points depends on the same factors as for the
static measuring method.
9.When finished, press the FN key to stop logging data. Turn off the
Rover if needed.
www.javad.com