Rain Cover; Summer/Winter Slip Sack - Otto Bock Kimba Neo Instructions For Use Manual

Installing options/accessories
2) If necessary: Remove the thoracic supports (see Page 20). Remove all other options screwed to the back sup­
port insert (see fig. 65, item 2) and back support frame (see fig. 65, item 3) so the back support insert can be
removed.
3) Loosen the set screws at the back support tubes (see fig. 65, item 1) and pull the tubes up and out.
4) Slide the canopy adapters with the proper side onto the tubes (see fig. 66).
5) Position the canopy adapters so they are level (see fig. 66).
6) Tighten the set screws on the canopy adapters.
7) Slide the tubes back in and tighten the set screws (see fig. 65, item 1).
8) If necessary: Install the thoracic supports (see Page 20). Mount all options that were removed.
9) Put the back support pad in place.
65

6.8 Rain cover

The installation is usually carried out by the user's attendant.
For mounting information, see the instructions for use (user).

6.9 Summer/winter slip sack

NOTICE
Incorrect attachment
Product damage due to attachment error
► During attachment of the slip sack, make sure that the product does not rub against the wheels.
1) If necessary, cut the slip sack at the intended locations with the leather applications so the following options
can be threaded through: lap belt (see fig. 67, no. 1), pommel and five-point belt (see fig. 67, no. 2), groin
strap (see fig. 67, no. 3).
2) Fasten the attachment cords (see fig. 67, no. 4) depending on the attachment situation:
→ Rear: e. g. on the seat plate (see fig. 68, no. 1)
→ Front: e. g. on the leg support tube (see fig. 68, no. 2)
67
28
66
68
Kimba Neo