Otto Bock Kimba Neo Instructions For Use Manual page 24

Installing options/accessories
51
1 Clips with rivet
2 Shoulder straps
3 Centre attachment straps
Mounting the positioning vest
1) Rivet the clips (see fig. 51, no. 1) in the bore holes of the back support (see fig. 52, no. 1; see fig. 53, no. 1).
2) Place the positioning vest on the seat bottom. The fastening straps (see fig. 51, no. 5) have to face the seat bot­
tom.
3) Thread the shoulder straps (see fig. 51, no. 2) through the padding and back support (see fig. 34) and secure
them in the clips at the back (see fig. 53, no. 2).
4) Run the middle and bottom attachment straps (see fig. 51, no. 3, 4) around the back support tubes to the rear
and secure them in the clips (see fig. 51, no. 1) (see fig. 53, no. 3).
5) If necessary, cut off protruding belt ends of the attachment straps and seal the loose ends by applying heat
(e. g. with a lighter).
52
24
4 Lower attachment straps
5 Fastening straps
53
Kimba Neo